Search found 6 matches
- Tue May 27, 2014 2:39 pm
- Forum: Subaru
- Topic: DCCD control
- Replies: 10
- Views: 28881
Re: DCCD control
Hi did this CAN based wheelspeed unit ever get sucessfully tested with a Syvecs S6 ECU?
- Tue Jan 21, 2014 11:41 am
- Forum: Subaru
- Topic: DCCD control
- Replies: 10
- Views: 28881
Re: DCCD control
Do I need DCCD slip control on a circuit car?.....probably not But maybe a better question would be: Does DCCD slip control improve lap times on a circuit car? I believe it does. Let's consider a real world example, Clearways and Clarke Curve at Brands Hatch At corner entry and toward the first apex...
- Mon Jan 20, 2014 1:29 pm
- Forum: Subaru
- Topic: DCCD control
- Replies: 10
- Views: 28881
Re: DCCD control
This is an intresting thread, the availability of a low cost CAN based wheel speed sensor would be a welcome upgrade for the S6 and will make the unit even more attractive than it is currently. Are there any plans to implement DCCD wheel speed slip control during the forthcoming season? I would welc...
- Sun Jan 20, 2013 12:19 am
- Forum: S6 GP/PnP Technical
- Topic: Digital Dash
- Replies: 6
- Views: 16691
Re: Digital Dash
I will probably end up with some more R&D or R$D as some like to put it lol ;) AIM for example refer to using a Stack stream over RS232 and not over CAN which suggests they never implemented the protocol. They do however list native CAN support for the Life Racing F88, which is essentially the ...
- Wed May 16, 2012 1:21 am
- Forum: S6 GP/PnP Technical
- Topic: Shiftlight/Downshift light
- Replies: 0
- Views: 10489
Shiftlight/Downshift light
Is it possible to invert the function of the shift light? i.e. light comes on when engine revs are BELOW the set target rather than above the target. The intention is to use the light as a prompt for down shifts to mitigate the risk of shifting too early and over reving the engine. Could be easily d...
- Wed Oct 26, 2011 1:46 am
- Forum: S6 GP/PnP Technical
- Topic: Throttle Blipper
- Replies: 1
- Views: 5727
Throttle Blipper
I have the following servo motor installed in my car.... http://www.hobbyking.com/hobbyking/store/catalog/HV380.jpg I'm looking to configure it as a throttle blipper for downshifts in conjunction with a sequential transmission/loadcell in shifting lever.... question is how do i configure and wire th...