Latest Firmware Releases

[Ryan.g]

Latest Firmware Releases for the Syvecs DI12 which have the USB Adjustment port as seen below

[Ryan.g]

Firmware 1.2 of the Syvecs DI12 Module is attached below.

Please use the Syvecs Updater program to load the ENC file. Guide here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

This Firmware is only for DI12 Modules which has the USB plug on the back of the Unit with removable HEX Plug

The 1.2 Firmware adds Scal software support to allow configuration of the DI12 Current levels and users must select Program - Defaults in Scal after programming the ENC below to load a default calibration. Adjusts can be made after.

https://www.syvecs.com/downloads/DI12_1-2-1.enc

[Ryan.g]

Firmware 1.3 of the Syvecs DI12 Module is attached below.

Please use the Syvecs Updater program to load the ENC file. Guide here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

This Firmware is only for DI12 Modules which has the USB plug on the back of the Unit with removable HEX Plug

Changes since 1.2

* Fast boost option - Boost is turned off when target current is met regards of the boost time set

https://www.syvecs.com/downloads/DI12_1-3-1.enc