Syvecs Forums

Is there a complete pinout for the slave section. The manual only goes to Slave AN06. In the software I see Slave AN28. Some info about this will help. Maybe I missed this in the manual but could not find it. Why is it slave and not regular inputs?

S6 Plus is pretty much an S6 plus an expander inside.

The Slave I/O's would refer to those on the expander

Up to 8 Slave outputs, and 6 slave inputs

http://www.syvecs.com/downloads/S6Plus% ... 20Info.pdf

CT9A,

you may find some more information in this thread

Hope this helps,

Pat.