Syvecs Forums

Hi everybody, I'm Raul from Spain, I'm new here and I hope somebody can solve my issues.
Finally I have my S6 repaired and working on my Celica Carlos Sainz after a shortcircuit due my Laptop.
I already buy some sensors and installed them as follows:

EGT K type sensor (ebay sensor)
THER+ Pin39 EGT+
THER- Pin62 EGT-

KNOCK sENSOR (Bosch one bought on Syvecs website)
Knock Input Pin17
Knock GND Pin18

BOOST SOLENOID (Pierburg one bought on Syvecs website)
Aux4 Pin5
VBAT Pin21 12V

Ok, So How can I do for that these sensor works on my ECU?

How I know I have to go:

SCal----Io Configuration----Pin Assignments...
And then?
Choose each sensor and appears differents options...which one I have to choose?

Thanks in advance.

Im guessing your using an S6GP, if so here is the pinout guide :-

viewtopic.php?f=6&t=401

Wez wrote:Im guessing your using an S6GP, if so here is the pinout guide :-

viewtopic.php?f=6&t=401

Yes, I'm using a S6Gp, and the installation and connection to the S6 is done.
But I don't know what I have to program exactly on the S6GP to read the measurements of the new sensors.

Any help?

Thanks.

Yes! Finally I have the sensors working, JUST NEED PRESS PROGRAM!!!
only the EGT sensor doesn't works properly, It's a ebay cheap KType thermocouple.
I will buy the syvecs one.

Thanks