Syvecs Forums

Hi Chaps,

I've had a good search around the forum and on the internet to find this information but so far I can't seem to find what I am looking for. Hopefully somebody can help here.

Is there a document that shows what each pin assignment is for with a standard ECU install? IE. If I put a V3/4 Syvecs into a V3/4 car what would be the standard pin assignments for the crank/cam sensors etc?

Thanks for any help offered,

Cheers,

Keith

All the info is on this forum.

Hi,

Thanks for the info, I have seen that information but I could see how that transfers over to this:



When I turn over the engine I get this:



Does anybody have any idea why I can't get Sync 720?

Thanks,

It may be that the IO's for the cam/crank have been swapped (i.e. if you've had an APEXI ecu previously?). In which case, try swapping the inputs over in IO config.

You might get a better idea of whats happening under DEVICE/VIEW SYSC LOG

Steve

Sorted it, thanks Steve.

That was the problem,

you're welcome & good luck.