Syvecs Forums

And input is configured as 5v ?

Datalog the raw input to see what it's doing/seeing.

All works fine on a couple of S8's I've done.

Ask on the Facebook group, more traffic there.

where do you configure the input as 5v?

Actually, you won't need to as you've used a 0-5 volt input that is not configurable.

On S8, it works easy. Unless there's something the S7 not happy with.

But log the raw input to see what is seeing.

i will log and see what is happening, just for future reference, how would you configure the inputs and outputs?, for example the H Bridges?

ok, traced the an04 input, get a nice 4.9v showing on the input, when the car is then started it goes from 4.9v to 1.22v then jumps up and down repeatedly. i think im going to disconnect the input and monitor with a scope and see if the input is the issue.

Odd.

Try and test as you say, measuring the Cartek white wire when not connected to the ecu.

I assume the blue button on the Cartek isn't flashing any faults ?

nice solid LED on the internal button, very odd indeed.

Just checked again, was in work and couldn't earlier.

C13 is a configurable input. So do you have the pullup off ? so it is just a regular 0-5v input

upload your cal

pull up is off, ill PM you the cal so you can check it over