X10 Firmware

[Ryan.g]

This Link is for version 1.5 of the X10 firmware

PLEASE ENSURE LATEST SSUITE SOFTWARE IS IN USE BEFORE UPGRADING FIRMWARE!!!

- Allows the Inputs 1-6 to send frequency signal across the Slave Can-bus like Turbo Speed, Wheel speed etc
- Control of H Bridges Allowed over Slave - See Note below

H Bridge assigning is Scal when using X10 Expander

- Slave1 Fuel11 is H Bridge1 (pin4 on x10)
- Slave1 Fuel12 is H Bridge2 (Pin30 on X10)
- Slave1 Fuel13 is H Bridge3 (Pin21 on X10)
- Slave1 Fuel14 is H Bridge4 (Pin22 on X10)

Full Bridge Assigning in Scal when using X10 Expander

- Slave1 Fuel11 is for Full Bridge1 (H Bridge 1&2)

- Slave1 Fuel13 is for Full Bridge2 (H Bridge 3&4)



Enjoy

[Ryan.g]

This Link is for version 1.9 of the X10 firmware

PLEASE ENSURE LATEST SSUITE SOFTWARE IS IN USE BEFORE UPGRADING FIRMWARE!!!

- Update to allow S7 Fixed Stream to all pass through on Can1 to Can2 of X10