Hey neex help connecting to syvecs

[Twinturbosyvecs]

Hey guys So i tried 2 dif laptops and 1 pc to connect to syvecs s12

When i try to connect to syvecs i have it on table all power and ground connected and the 4 ethernet wires

Software says no device found

I am using win 11

My pc shows a network is opened and there is a ip address populated

Please help thank you

[stevieturbo]

Annoyingly, sometimes mine will not connect.

I simply re-install the software, it only takes a few seconds and then it will connect.

This appears to happen at random. Sometimes it works fine, sometimes it just does not.

Power everything up as normal, re-install the SSuite software and see if that changes anything

[Twinturbosyvecs]

Tried that and tried 3 different pcs

2 laptops with usb ethernet and 1 with desktop

[stevieturbo]

If you open SMsgs, or SMon does it attempt to connect ?

Are you sure the ecu is definitely powered up and live ? and ethernet cable wired correctly ?

[Twinturbosyvecs]

Yes it does and it gives ip address

And it does try connecting but shows no devices are available

[stevieturbo]

Can't comment on whether it should or should not appear like that.

I've plugged a spare ecu into a Wifi router, and when connected to my W11 PC sitting here via WiFi, this is how my config appears, 5G Wifi connection

syvecsconnect.jpg (114.31 KiB) Viewed 3213 times

And annoyingly...again the RTC clock battery is flat. This was changed only a year ago !

[stevieturbo]

and from control panel info

syvecsconnect2.jpg (108.19 KiB) Viewed 3212 times

[Twinturbosyvecs]

Thanks alot for the info

On the table which pins are you connecting?

3 power 5 ground? And the 4 network?

Which syvecs do you have.

[stevieturbo]

This is an S8 I have for bench testing.

But on an S12, yes any power ground and battery supply should do for power, and the 4 LAN pins


http://www.syvecs.com/downloads/S12_Pin ... g_Info.pdf

[Twinturbosyvecs]

So still no device found

Tried 3 computers at this point, 2 different usb to ethernet and 1 pc with built in ethernet


Reinstalled software still nothing

I also confirmed 5 volt out is working

Any ideas ? This is crazy