Scfg 1.518.1 file to 1.538

[R8GT]

Hi,

I am trying to set (Load) a new Scfg calibration onto my ECU.

The file I am using is from my tuner, and is Scfg Software Version 1.518.1.

When trying to Set the file onto my ECU using Scfg, I get and error that requests I convert the file to 1.538

I am using, and only have ever loaded, the latest software and firmware. I have no older versions on my PC.

When trying to convert the file in Scfg from 1.518.1 to 1.538, I obviously don't have anything in the directory the pops us that is obvious to use to convert the file.

Can someone help with this process pls.

Thanks.

[Wez]

I think it is prob similar to updating a cal, in sCfg there is an option to change software version.

Open your file, change version in sCfg, save the new version and try that?

[R8GT]

Thanks for the reply Wez, it did help me figure out the problem.

I did not have the firmware update file correctly located in my workspace, so could not find it when using the Config / change software version facility in SCfg.

All sorted and working now. Thanks again.