Wideband wiring

[Jez]

I'm currently using a wideband interface that communicates to the Solaris via a 0-5v signal wire.

I'd like to remove this gauge and connect the WBLS directly to the Solaris.

Would this be the correct wiring:

Code: Select all

Solaris        - WBLS
WBLS signal    - Vs
WBLS pump      - Ip
WBLS ground    - Vs/Ip
WBLS heater    - H-
+12v           - H+

[Ryan.g]

Hi Jez

Which sensor are you using?, As if its an LSU4 they are currently not support.

I know solaris are working on this but the heater calibrations for the LSU4 is not easy to setup compared to the NTK units.

If its an NTK sensor then it will work no problem

Ryan

[Jez]

Hmmm... I'll have to check - I think it may be an LSU type...

[Jez]

Anyone got a good source for the NTK sensors?

[Ryan.g]

Im sure Pat has some spare