CAN Bus assignment
Posted: Tue Jan 21, 2020 11:18 am
Hi,
Got a loom to do and have the following CAN devices to attach.
S8
Motec PDM30 + Keypad
Motec C125
ECUMaster Can switch v3 board
Syvecs 50hz GPS
Bosch M4 ABS (and yaw sensor obviously)
Is there any benefit in moving any of the devices to CAN2 - I seem to remember that ABS has to be on CAN1?
(ABS is 1Mbit)
I was previously using custom CAN to integrate with the PDM when I had it on the desk over a year ago.
Thanks
Got a loom to do and have the following CAN devices to attach.
S8
Motec PDM30 + Keypad
Motec C125
ECUMaster Can switch v3 board
Syvecs 50hz GPS
Bosch M4 ABS (and yaw sensor obviously)
Is there any benefit in moving any of the devices to CAN2 - I seem to remember that ABS has to be on CAN1?
(ABS is 1Mbit)
I was previously using custom CAN to integrate with the PDM when I had it on the desk over a year ago.
Thanks