Syvecs Forums

Get asked alot about this tool so here is a link of where to purchase the tool for removing the Small pins from the S6GP

http://shop.t-g-s.de/product_info.php?p ... 1335044350

This Link is for S6 Firmware version 1.28 (PLEASE NOTE IF UPDATING FIRMWARE ON A DBW EQUIPPED INSTALLATION TO SEE NOTES IN RED) Changes in this release are as follows : 1) Launch control augmentation (as in S8): * launch limiter ignition cuts and new safety fuel cut map * launch control re-activatio...

Not sure how many have spotted this yet but i have uploaded a basic manual which should be useful for most owners to do Datalogging etc, link below

viewtopic.php?f=8&t=322&p=1472#p1472

Ryan

Hi Bart,

This must be an issue with the new Dash2 config software.

I would suggest speaking to Lorne at Race Technologies and send him config file

Ryan

Added to Firmware tracker guys as in some cases is useful

viewtopic.php?f=14&t=174

Sent you Mail Anthony

:thumbs:

The Below Link is for version 1.25.1 of the S6 firmware. This is a features / tweaks release and adds the following : http://www.syvecs.com/downloads/S6v1-25-1(5).exe // Cll service time calibration Allows users now to adjust Service time of Closed loop Lambda based on Rpm vs Primary Load, very usef...

S6GP Pinouts and Wiring Guide

:Please Note - Input Pinouts and Sensor wiring are EXAMPLES of ways it can be done and can be populated based on Input types available:

Ryan@syvecs