Syvecs Forums

The Cal Up and Down signals come in over CanBus and hence not assigned in the pin assignments. When the cruise lever is not in the on position ie pulled back from memory you can push it up to activate the Cal Up in the ECU and down for the opposite. Check that the Cal Overide is Not ON either as tha...

Hi, The Brake by wire and Fan assignments can all be turned into Custom maps. So you would first click V, C to get into the customising window on the latest software and firmware. Here you would want to use a Fan output which is setup for PWM and has a (PWM) assigned... Like Fan6 Then on the Output ...

Grab the latest firmware and you will see on the Cut Enable now it can be set on GearShiftDirection now

Time and cut amounts can be adjusted also depending on shift direction

Is really straight forward now with the Latest firmware 1.64+

Email support@syvecs.com for base map for this is needed

Few Updated Help Videos on our YouTube Page

https://www.youtube.com/user/SyvecsHelp/videos

This Link is for version 1.551 of the S12 firmware. PLEASE ENSURE LATEST SSUITE SOFTWARE IS IN USE BEFORE UPGRADING FIRMWARE!!! Help Video on new firmware below https://youtu.be/IVIdYESOuOQ Changes since 1.527 * centre diff handbrake throttle threshold range now -25..125 * wowSwitch available via ge...

This Link is for version 1.551 of the S8 firmware. PLEASE ENSURE LATEST SSUITE SOFTWARE IS IN USE BEFORE UPGRADING FIRMWARE!!! Changes since 1.527 * centre diff handbrake throttle threshold range now -25..125 * wowSwitch available via gen can rx * n2oSwitch available via gen can rx * loggingSwitch a...

This Link is for version 1.64 of the S6 firmware. PLEASE ENSURE LATEST SSUITE SOFTWARE IS IN USE BEFORE UPGRADING FIRMWARE!!! http://www.syvecs.com/downloads/SyvecsSetup-Generic-2016-03-22.exe Help Video on Firmware below https://youtu.be/IVIdYESOuOQ Updates from 1.59 * VK56 crank pattern support * ...

Its very strange to see one not covered in sand but surrounded with GREEN!

As said on Email, i hate the car lol but will look into sniffing the canbus for you. You can do the rest

Not at the moment but in a few weeks times when our new firmware gets released it will allow you to create comp maps for Wastegate etc and have a custom map for Wg Target Trim based on say EGT vs ACT