Syvecs Forums

I'm getting an error when trying to run SyvecsSetup-Generic-2024-04-15.exe

Seems like signing or some crap on windows 11, any points appreciated!

I don't think any of that is needed. You need to cut blip cut. You need to make the ALS consistent, that is, either turn it OFF or tune it properly. Using the dog preparation cut with ignition cut for about 40ms gives you time to reintroduce fuel while opening the throttle. And then when the ignitio...

You don' t need custom firmware to do this. You can reprogram the keypad to send data in a format the S7 or above can read on custom can import.

Because an idle valve is a proportional device. The diode stops the back EMF, (I think) the back EMF from the collapse the magnetic field will effect the field being reestablished during the next pulse, so you're average field strength is reduced. What we want is a more of an averaged constant curre...

^^^^^^^^^^^
What he said

I used 300hz on a 2wire valve, it absolutely needs a flyback diode to work properly. My PWM output looks like this:

Not really Tim. In this case we are just using the vehicle speed as a stationary/moving status flag. If the GPS speed were 100% reliably then we could perhaps start to do some better things with it, as it becomes a "5th wheel" speed which can can peg RPM against. If you switch from a timer...

Hi John, It's good to see you're taking in an interest in your setup again! The reason your activation speed is set so low is to try and overcome the delay the occurs due to the speed converter fitted on your car. When we initially set it up at Combe in 2014 that was causing a problem with prompt ac...

Cam phase comes from the exhaust cam and will be static on single MIVEC evo head.

You want to look at VVT1inRaw which is what you should use for fine tuning latch angles for the VVT.

You may actually require a cut for a downshift, if you are under power! Later firmware versions have this option, and it works well. I would advise thought that full gearbox control is not something for beginners to set up. A few questions: This is an S8 right? And it is an S8 with full gear control...