Syvecs Forums

Posted: **Mon Jun 26, 2017 10:56 am**

Hello All,

I am looking for some advice/assistance in connecting a Syvecs Bluetooth Module to my S6PNP on my Subaru MY99.

The Bluetooth Module install guide advises that Pin4 is Ground, Pin5 is RS232 TX, Pin6 is RS232 RX and Pin 7 +12v Power Batt/ECU.

Looking at my Syvecs ECU there are several connectors on the rear, the one I'm interested in is the Comms RJ11/RJ25 connector for CanBus/RS232.

Is there a cable I can get to help connect the RS232 RX&TX from the CanBus RJ11/RJ25 port to the Bluetooth module ?

Any help or guidance is appreciated.

TIA

CharlesTuna

Posted: **Wed Jan 24, 2018 10:40 am**

Charles, did you get and answer on this?

I also have the RS232 pins already taken up by a Comms connector (in my case an RJ45).

Ideally a cable from this to the bluetooth would save a lot of trouble !

Syvecs Forums

Subaru MY99/00 S6PNP & Syvecs Bluetooth Module help needed

Subaru MY99/00 S6PNP & Syvecs Bluetooth Module help needed

Re: Subaru MY99/00 S6PNP & Syvecs Bluetooth Module help needed