Syvecs Forums

I was getting annoyed trying to find the markings, so downloaded a CAD image of the connector and added the numbers.. available here (Someone (pat!) will now tell me that these exist already!)

https://drive.google.com/a/wallis2000.c ... sp=sharing

Can't get access to your google drive from that link, but there's a picture of the S6 connector in the technical guide available from here...

try this https://drive.google.com/file/d/0B9biRO ... sp=sharing

In manuals and pinouts it gives a picture

http://www.syvecs.co.uk/support/product ... d-pinouts/

Page 2 of the manual

http://www.syvecs.com/downloads/Syvecs% ... 20V1.1.pdf

Although your image is very clear which is handy

Or this, I just reversed the image, so it refers to looking into the actual loom connector which can be handy tracing pins on the loom ( although might need to hold connector the right way up lol ) Once you know where 1 is, it should make sense I think



Or looking into ecu

Nice! would have saved me a little time (only a little - didnt take that long )

Well Ill leave the image on there, it may help others in the future