Syvecs Forums

Posted: **Sun Sep 21, 2008 7:57 pm**

I'm currently using a wideband interface that communicates to the Solaris via a 0-5v signal wire.

I'd like to remove this gauge and connect the WBLS directly to the Solaris.

Would this be the correct wiring:

Code: Select all

Solaris        - WBLS
WBLS signal    - Vs
WBLS pump      - Ip
WBLS ground    - Vs/Ip
WBLS heater    - H-
+12v           - H+

Posted: **Mon Sep 22, 2008 5:07 pm**

Hi Jez

Which sensor are you using?, As if its an LSU4 they are currently not support.

I know solaris are working on this but the heater calibrations for the LSU4 is not easy to setup compared to the NTK units.

If its an NTK sensor then it will work no problem

Ryan

Posted: **Mon Sep 22, 2008 9:05 pm**

Hmmm... I'll have to check - I think it may be an LSU type...

Posted: **Mon Sep 22, 2008 9:13 pm**

Anyone got a good source for the NTK sensors?

Posted: **Tue Sep 23, 2008 8:18 am**

Im sure Pat has some spare

Syvecs Forums

Wideband wiring

Wideband wiring

Re: Wideband wiring

Re: Wideband wiring

Re: Wideband wiring

Re: Wideband wiring