Integrating S8 with Race Technology Dash2
Posted: Mon Mar 04, 2024 12:34 pm
First up, I don't have any previous experience of this so be gentle! I have a V12 XJ13 aluminium replica in build which is using a Syvecs S8 ECU and for IVA purposes we are putting it through with a Race Technology Dash2 display. We have verified the CAN data stream out of the Syvecs with a Syvecs logger and that is working fine. We have the CAN interface box from Race Technology as well. So we now need to get the Dash2 display showing the relevant information from the CAN stream. We have tried getting support from Race Technology but frustratingly that has not been forthcoming.
Question: Does anyone have the config set for a working Dash2 setup - i.e. the Syvecs calibration, the config of the CAN<>RS232 converter box and the Dash2 configuration? I understand that all these must match for the setup to work.
Anything along the lines of an idiot's guide to installing these would also be appreciated!
Thanks
Craig
Question: Does anyone have the config set for a working Dash2 setup - i.e. the Syvecs calibration, the config of the CAN<>RS232 converter box and the Dash2 configuration? I understand that all these must match for the setup to work.
Anything along the lines of an idiot's guide to installing these would also be appreciated!
Thanks
Craig