Page 1 of 1
CalSelct Display on Tacho (for old pulsed tacho cars)
Posted: Fri Oct 06, 2023 4:26 pm
by amdisthebest
Like all the modern kits do with CAN bus, it would be awesome if all the old cars out there with a pulsed tacho could get calSelect displayed temporarily on the tach like the new kits.
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
Posted: Fri Oct 06, 2023 6:37 pm
by stevieturbo
Is the number on a rotary switch too hard to see ?
And how would you propose that worked on your tacho whilst driving ?
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
Posted: Sat Oct 07, 2023 5:30 am
by amdisthebest
I don't have a rotary switch. I use factory toggle buttons in a stalk, repurposed for map selection.
The tach would temporarily display the selected map as the maps are being changed then after a short pause, return to displaying engine speed, just like a Syvecs CAN based system...
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
Posted: Sat Oct 07, 2023 9:54 am
by stevieturbo
amdisthebest wrote: ↑Sat Oct 07, 2023 5:30 am
I don't have a rotary switch. I use factory toggle buttons in a stalk, repurposed for map selection.
The tach would temporarily display the selected map as the maps are being changed then after a short pause, return to displaying engine speed, just like a Syvecs CAN based system...
Ahh right, you said this was for an old car.
Conventional rotary switch is a lot more practical. Especially if you ever wish to make changes on the move and be sure where you change to.
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
Posted: Wed Feb 07, 2024 8:10 pm
by amdisthebest
There's lots of other ways I could do it, but I prefer my OEM integration and would love a display.
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
Posted: Tue Apr 16, 2024 5:20 am
by Ryan.g
This is now done guys, will release with 1.752 firmware today
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
Posted: Thu Apr 18, 2024 5:44 am
by amdisthebest
Ryan.g wrote: ↑Tue Apr 16, 2024 5:20 am
This is now done guys, will release with 1.752 firmware today
Loaded and tested yesterday. Works perfect Ryan. Thank you!