Page 1 of 1

Throttle Blipper

Posted: Wed Oct 26, 2011 12:46 am
by Paul Doyle
I have the following servo motor installed in my car....

http://www.hobbyking.com/hobbyking/stor ... /HV380.jpg

I'm looking to configure it as a throttle blipper for downshifts in conjunction with a sequential transmission/loadcell in shifting lever....

question is how do i configure and wire the device?....will one of my S6GP outputs drive it directly or do i need a PWM driver unit....

thanks in advance

Re: Throttle Blipper

Posted: Wed Oct 26, 2011 10:35 am
by pavlo
Exactly as it was wired in at Snetterton.

Setup exactly as it was setup at SNetterton