Re: Output Test Mode Question - Can't Enable Output
Posted: Sat Jul 21, 2018 12:04 pm
I wired mine as per Haltech drawing.
I did also try with and without the resistor and in both cases it worked fine...but left the resistor in anyway.
Not sure how to enable this as such in test mode....for testing the FP output I just set prime time to say 30secs and hit D/P to restart the ecu which kicks it on for 30s and would be at the "prime" duty cycle.
I don't know if you can actually operate the ecu outputs in test mode as a chosen PWM signal ?
It would be helpful if you could...likewise for likes of ignition outputs, test at a chosen RPM for example rather than manual off/on pulses.
I did also try with and without the resistor and in both cases it worked fine...but left the resistor in anyway.
Not sure how to enable this as such in test mode....for testing the FP output I just set prime time to say 30secs and hit D/P to restart the ecu which kicks it on for 30s and would be at the "prime" duty cycle.
I don't know if you can actually operate the ecu outputs in test mode as a chosen PWM signal ?
It would be helpful if you could...likewise for likes of ignition outputs, test at a chosen RPM for example rather than manual off/on pulses.