Porsche 996TT S6+ Wiring

For Porsche Technical Chat

Moderator: Wez

Post Reply
Wez
Santa's Little Helper
Posts: 267
Joined: Thu May 22, 2008 2:19 pm
Location: London

Porsche 996TT S6+ Wiring

Post by Wez »

Hey All,

Where would you wire calibration / traction switch inputs and a flex-fuel sensor into a 996TT running an S6+?

Thanks

Wes
96 MKIV Supra, S6GP, 591bhp & 523ft/lbs
stevieturbo
Posts: 975
Joined: Sun Dec 07, 2008 2:04 pm

Re: Porsche 996TT S6+ Wiring

Post by stevieturbo »

Does the manual not cover the pinouts ?

If you dont have a specific pinout for the car, if you looked through the I/O config it would show you which inputs are free to use ?
Wez
Santa's Little Helper
Posts: 267
Joined: Thu May 22, 2008 2:19 pm
Location: London

Re: Porsche 996TT S6+ Wiring

Post by Wez »

I havent seen an S6+ 911 manual, I do have the S8 manual which points to AN12 for calibration, on the S6+ wiring diagram this is used for MAF.

It looks like AN01, AN04 and ANS6 are free on the wiring chart, also possibly ANS5 on a 996 as this is listed as EOP for a 997.
96 MKIV Supra, S6GP, 591bhp & 523ft/lbs
stevieturbo
Posts: 975
Joined: Sun Dec 07, 2008 2:04 pm

Re: Porsche 996TT S6+ Wiring

Post by stevieturbo »

Even if you had to move a pin or two about and re-configure, it would be very easy with the plugs on the plus. Pins are dead easy moved and swapped.
Post Reply