Cannot connect via ethernet
Posted: Mon Feb 06, 2017 1:45 pm
Hi All - A new and fairly unwelcome gremlin has reared its ugly head today.
After going to the latest Software Suite (05-12-2016) - though this may well be entirely coincidental.
http://www.syvecs.com/downloads/SyvecsS ... -12-02.exe
I am now unable to connect to my ECU via ethernet - error message "There are no devices available" within SCal - but oddly I can see there is a connection as there is a ip addr on the network adaptor in question.
Have swapped out network cables and performed a connectivity test on the ethernet port to the ECU - oh and three different laptops.
Next up is trying lo locate the previous version of the Software Suite.
I'm on 1.74 of the firmware and the car is still starting and running so I know the ECU is 'alive'!
And suggestions would be greatly welcome....
After going to the latest Software Suite (05-12-2016) - though this may well be entirely coincidental.
http://www.syvecs.com/downloads/SyvecsS ... -12-02.exe
I am now unable to connect to my ECU via ethernet - error message "There are no devices available" within SCal - but oddly I can see there is a connection as there is a ip addr on the network adaptor in question.
Have swapped out network cables and performed a connectivity test on the ethernet port to the ECU - oh and three different laptops.
Next up is trying lo locate the previous version of the Software Suite.
I'm on 1.74 of the firmware and the car is still starting and running so I know the ECU is 'alive'!
And suggestions would be greatly welcome....