slave AN pinout info needed

[CT9A]

Is there a complete pinout for the slave section. The manual only goes to Slave AN06. In the software I see Slave AN28. Some info about this will help. Maybe I missed this in the manual but could not find it. Why is it slave and not regular inputs?

[stevieturbo]

S6 Plus is pretty much an S6 plus an expander inside.

The Slave I/O's would refer to those on the expander

Up to 8 Slave outputs, and 6 slave inputs

http://www.syvecs.com/downloads/S6Plus% ... 20Info.pdf

[pat]

CT9A,

you may find some more information in this thread

Hope this helps,

Pat.