Power up issue

dr_jones
Posts: 162
Joined: Wed Jun 08, 2016 3:24 pm

Re: Power up issue

Post by dr_jones »

All sorted now - Pat (Syvecs) - pointed me towards jumper (well solder bridge) SB12 which was in the incorrect configuration for my application.

-Ed.
stevieturbo
Posts: 1321
Joined: Sun Dec 07, 2008 2:04 pm

Re: Power up issue

Post by stevieturbo »

dr_jones wrote:Oh - I need to read further - the first two parts appear to be only related to backing up prior to updating.
Makes sense, you need to alter any logging configs etc after the firmware change.

But the firmware program/file just does the job itself, without any other software required.
Post Reply