Silicone joiners with air temp sensor boss

Post Reply
TimH
JT Innovations
Posts: 718
Joined: Wed Sep 01, 2010 3:51 pm

Silicone joiners with air temp sensor boss

Post by TimH »

If anyone's interested, I now have some silicone reducers available with a moulded-in 10mm boss, ready to accept most common air temp sensors. This should make Syvecs installations that little bit easier, with no need to drill holes, and/or no need to make use of epoxy resin (with a good sprinkling of luck) to keep the sensor in place ;)

Two different sizes:
  • 70mm-to-63mm (standard Subaru throttle body to smaller FMIC pipework such as Hybrids)
  • 70mm-to-76mm (standard Subaru throttle body to larger FMIC pipework such as APS or Hyperflow)
Both are 82mm long, and a 63mm-to-63mm coupler will be available soon. In black only for now until I gauge the level of interest.

These are made for us by SFS, so there should be few concerns about their quality :D

£49.99+VAT each.

Image
Image
Image
Post Reply