Race Tech Dash2 Config Files Pack HERE

[Ryan.g]

Hi all

Here is the config pack for the Dash2

In the zip file you have:

Can adaptor flash file
Basic Dash2 config file
Syvecs cal file with Custom can bus data to match can adaptor config - PasteCal all Can stuff into your map

See attached

Ryan

[Ryan.g]

Found a slight error with the frame content on one of the sensors and now updated within the package above

Ryan

[Wez]

Top stuff matey, I was going to call you about these bits and pieces

[wrxbart]

Hi tried to load your file onto my dash2 but it only gets to 99% then stops and the dash then goes into a fail mode with no back light and only parts of the dash working. You then have to do a dash 2 reflag with the original software to get it back to standard again. Any help available to sort this?

[Ryan.g]

Hi Bart,

This must be an issue with the new Dash2 config software.

I would suggest speaking to Lorne at Race Technologies and send him config file

Ryan

[wrxbart]

Ok many thanks mate will do.

[tarmac terror]

Has this now been resolved??

TT

[Ryan.g]

Yes Lorne has updated so you can select Syvecs on software now.

[ders]

Any information on how this interface will work with the new Dash 2 Pro, which is touting a direct 1M CAN interface? Or will we have to sit and wait for the 'comming soon' to be formally elaborated on by RT?

[pavlo]

It's easy. The new range of RT stuff is great, and the current software a quantum leap in terms of speed.

The new system means just unlock 15 CAN channels and configure them in the same way as you used to with can->serial adaptor. The Syvecs also outputs direct RT serial stream too.

The Dash 2 Pro is based on the new DL1 processor platform so some of the stuff is taking a little while to get ported over, but it's all coming along nicely, I spoke to Martin at RT a few days ago and they marching on with all that stuff.