Search found 14 matches
- Fri Mar 08, 2019 8:57 am
- Forum: General Syvecs Chat
- Topic: paddle shift problem
- Replies: 8
- Views: 10218
paddle shift problem
my car has developed a gear shift problem . stated to get a few shift problems on a test session .and next time i went to go out i could not select gears mainly down shifts . since then i did find a suspect upshift limit switch that i have changed but problem is now i can select up shifts fine. but ...
- Tue Feb 21, 2017 6:06 pm
- Forum: X10 (Legacy - Gen1)
- Topic: connections
- Replies: 4
- Views: 14835
Re: connections
found out CAN2 had to go CAN 1 on x10 unit
and have since found out i have to connect the LAN cable to configure.
QUESTION i have connected the LAN cable but if i plug computer into it i cant see it . in cal software .
what software do i need to connect to unit
and have since found out i have to connect the LAN cable to configure.
QUESTION i have connected the LAN cable but if i plug computer into it i cant see it . in cal software .
what software do i need to connect to unit
- Fri Feb 03, 2017 4:55 pm
- Forum: X10 (Legacy - Gen1)
- Topic: connections
- Replies: 4
- Views: 14835
Re: connections
i believe my wheel sensors are 12v but will check to see if they can run on 5v
- Wed Feb 01, 2017 3:15 pm
- Forum: X10 (Legacy - Gen1)
- Topic: connections
- Replies: 4
- Views: 14835
connections
hi newbie to these ecus and expanders . need to use i/o expander and wondered what were the best input and outputs to use i have 10 inputs front wheel sensor n/s front wheel sensor o/s rear wheel sensor n/s rear wheel sensor o/s paddle shift up paddle shift down cal 1 cal 2 cal 3 air pressure output...