Search found 355 matches
- Thu Jul 10, 2008 9:19 pm
- Forum: S6 GP/PnP Technical
- Topic: Fitting and wiring questions
- Replies: 5
- Views: 13445
Re: Fitting and wiring questions
Jez, Do resistive inputs measure resistance to ground? Yes, exactly that. There is a pull-up resistor inside the ECU on these inputs that try to pull the pin up to +5V. What are THER+ / THER- connections? Are they EGT thermocouple inputs? Correct again, they are for use with K Type thermocouples, an...
- Thu Jun 26, 2008 8:44 pm
- Forum: Technical Deposit
- Topic: Turbo speed sensor
- Replies: 5
- Views: 25177
Re: Turbo speed sensor
This shaft speed sensor was designed to be used with "conventional" rev counters, and as such has a few caveats when used in conjunction with a Solaris ECU : From the ECU's perspective : One pulse is expected per blade The number of blades is defined in the sensor setup, so that the shaft ...
- Thu Jun 26, 2008 8:21 pm
- Forum: S6 GP/PnP Technical
- Topic: Injector Drivers
- Replies: 3
- Views: 9887
Re: Injector Drivers
Just a little supplemental info : The injector driver transistors can cope with a continuous 10A drain current, which exceeds the requirement for most, if not all, Peak&Hold injectors (it is unusual to see more than 4A hold current) The timing processor has sufficient spare logic to modulate the...
- Wed May 28, 2008 10:31 pm
- Forum: S6 GP/PnP Technical
- Topic: Dashboard Display interfaces
- Replies: 1
- Views: 6778
Re: Dashboard Display interfaces
Karl, In a word, YES :D There are at least two interfaces on the ECU that can be used, an RS232 and one (or two) CAN interface(s). In the configuration you can choose which telemetry protocol to send and where to send it. Anything that has "CAN" after it goes down the CAN bus, otherwise it...
- Fri May 23, 2008 10:35 am
- Forum: General Syvecs Chat
- Topic: Testing
- Replies: 2
- Views: 6999
Re: Testing
Seems to be working