Search found 355 matches

by pat
Thu Jul 10, 2008 9:19 pm
Forum: S6 GP/PnP Technical
Topic: Fitting and wiring questions
Replies: 5
Views: 13338

Re: Fitting and wiring questions

Jez, Do resistive inputs measure resistance to ground? Yes, exactly that. There is a pull-up resistor inside the ECU on these inputs that try to pull the pin up to +5V. What are THER+ / THER- connections? Are they EGT thermocouple inputs? Correct again, they are for use with K Type thermocouples, an...
by pat
Thu Jun 26, 2008 8:44 pm
Forum: Technical Deposit
Topic: Turbo speed sensor
Replies: 5
Views: 23733

Re: Turbo speed sensor

This shaft speed sensor was designed to be used with "conventional" rev counters, and as such has a few caveats when used in conjunction with a Solaris ECU : From the ECU's perspective : One pulse is expected per blade The number of blades is defined in the sensor setup, so that the shaft ...
by pat
Thu Jun 26, 2008 8:21 pm
Forum: S6 GP/PnP Technical
Topic: Injector Drivers
Replies: 3
Views: 9651

Re: Injector Drivers

Just a little supplemental info : The injector driver transistors can cope with a continuous 10A drain current, which exceeds the requirement for most, if not all, Peak&Hold injectors (it is unusual to see more than 4A hold current) The timing processor has sufficient spare logic to modulate the...
by pat
Wed May 28, 2008 10:31 pm
Forum: S6 GP/PnP Technical
Topic: Dashboard Display interfaces
Replies: 1
Views: 6694

Re: Dashboard Display interfaces

Karl, In a word, YES :D There are at least two interfaces on the ECU that can be used, an RS232 and one (or two) CAN interface(s). In the configuration you can choose which telemetry protocol to send and where to send it. Anything that has "CAN" after it goes down the CAN bus, otherwise it...
by pat
Fri May 23, 2008 10:35 am
Forum: General Syvecs Chat
Topic: Testing
Replies: 2
Views: 6900

Re: Testing

Seems to be working :)