Syvecs Forums

Same with avast, sometimes it blocks the firmware downloads or transfers on computer.

Likewise, even the Syvecs webpage throws a warning first time you try and open it. Second time it usually opens though.

post a picture of the coil pack, there will be many

ford racing wrote:Hi i have been running an msd rpm switch to activate an air shifter.but now want to activate the air shifter with the s8.is it possible to use an output to supply an earth to a relay at a given rpm

In it's most simple form....shift light output.

Handiest way is get a Mityvac ( one that lets you apply pressure too ) or a compressor/regulator and apply pressure to the sensor and monitor voltage on the ecu.

That way you know for sure it's calibrated correctly.

Helicoil where it bolts to down to 8mm or something, or make up a 10-8mm stud.

I considered drilling it....but it's probably not a great idea

I havent tried it as my car does not have ABS, and I just fitted hall triggers to my car. But it will cost very little to try, especially with the yellow relay if you can pick one up second hand You could try this device too, as think it allows any pulsed input signal, VR or hall, and you can adjust...

I presume ABS is still active ? Not sure if there is any useful info here ? http://www.syvecs.com/forum/viewtopic.php?f=6&t=553 I guess worst case, you could install a hall sensor somewhere, whether near a wheel or the propshaft and sort a trigger wheel for it ? Or is there a GPS module that can...

What wheelspeed sensors are you using ?

Not just pair one of those into speedo and ecu ?

I do that with a hall sensor.

There won't be an android version... buy a Toucan ;) :P But I might be biased :) A little bigger screen would be nice lol I was hoping for a 7" tablet, they're cheap as chips and would have been great...would have been a better option than that expensive icrap stuff Maybe Santa will be nice an...

Seems there is no Android version yet then ?