Search found 14 matches

by firepete
Thu Dec 24, 2020 8:15 pm
Forum: Technical Deposit
Topic: Race Tech Dash2 Config Files Pack HERE
Replies: 10
Views: 25507

Re: Race Tech Dash2 Config Files Pack HERE

will this work with life ecu also and dash 2pro
by firepete
Sat Jun 06, 2020 9:53 am
Forum: X10 - I/O Expander
Topic: pin outputs should they have any voltage on them
Replies: 4
Views: 2647

Re: pin outputs should they have any voltage on them

i have checked al my inputs and outputs and they all show 6v to earth .on the x10 .but not on the ecu . im trying to find a fault why my exhaust vvt does not work . the inlet solenoid is operated from ecu but exhaust had to come off the x10 it has worked in the past but failed a few times so had it ...
by firepete
Tue Jun 02, 2020 5:52 pm
Forum: X10 - I/O Expander
Topic: pin outputs should they have any voltage on them
Replies: 4
Views: 2647

pin outputs should they have any voltage on them

x10 outputs should there be any voltage on them with the ignition on . im finding im getting 6v to earth. what would cause this .
i was under impression it was a ground return to operate via ecu
by firepete
Thu Mar 28, 2019 9:49 pm
Forum: General Syvecs Chat
Topic: paddle shift problem
Replies: 8
Views: 6196

Re: paddle shift problem

all seemed to work in anger .
by firepete
Tue Mar 19, 2019 9:19 pm
Forum: General Syvecs Chat
Topic: paddle shift problem
Replies: 8
Views: 6196

Re: paddle shift problem

i have lowered the settings in the downshift from 15ms to 10 ms and this has sorted the problem [downshift positive return time]
by firepete
Fri Mar 15, 2019 6:32 pm
Forum: General Syvecs Chat
Topic: paddle shift problem
Replies: 8
Views: 6196

Re: paddle shift problem

gearbox striped down and no faults found .
by firepete
Mon Mar 11, 2019 12:17 pm
Forum: General Syvecs Chat
Topic: paddle shift problem
Replies: 8
Views: 6196

Re: paddle shift problem

YES HEWLAND FTR gearbox i only recalibrated just in case but voltages was pretty close . i have looked closer and i think the lever is bouncing out and mechanically upshifting again . i found a setting in the gear shift /down shift /down shift positive return time f[gear]they are set to 15ms i just ...
by firepete
Sun Mar 10, 2019 9:44 pm
Forum: General Syvecs Chat
Topic: paddle shift problem
Replies: 8
Views: 6196

Re: paddle shift problem

sorry it hewland ftr in a mygale ff200 using pneumatic actuator from paint ball bottle driven from ecu . set up been same for 2 years with not problems . started to have a couple of missed shifts on a test session last week . and when went to go out on next run had trouble with selecting reverse the...
by firepete
Sun Mar 10, 2019 4:29 pm
Forum: General Syvecs Chat
Topic: paddle shift problem
Replies: 8
Views: 6196

Re: paddle shift problem

i have just removed rear gearbox cover and oil and gears look perfect . that is with out removing any thing yet..then i remembered the air shift solenoids have a manual push button override .so i have tried this and gears select perfect but they dont stay in gear on the paddle and ecu control . anyo...