Thanks a lot, Pat!
The 360 sync is alright to me, I'm just getting the engine running. It works fine after setting Cam and crank type to single gap single cam and assigning cam to an input.
Search found 4 matches
- Mon Apr 18, 2016 8:53 pm
- Forum: S6-I / S6Plus Technical
- Topic: Crank setup
- Replies: 4
- Views: 10205
- Tue Apr 12, 2016 6:45 am
- Forum: S6-I / S6Plus Technical
- Topic: Bosch LSU 4.9 Lambda Sensor
- Replies: 4
- Views: 15584
Bosch LSU 4.9 Lambda Sensor
Hi, I want to connect a Bosch LSU 4.9 lambda probe to the S6Plus but I don’t know how to setup the heater. Currently, I have 30 s full power heating and then constant 10 V driver voltage, the Pin Assignment for Lambda Heater 1 is Slave1 Out9. However it says no signal. Does anyone run a LSU 4.9 and ...
- Tue Apr 12, 2016 6:35 am
- Forum: S6-I / S6Plus Technical
- Topic: Crank setup
- Replies: 4
- Views: 10205
Re: Crank setup
Thanks a lot for your fast response! I’ll try it later.
- Mon Apr 11, 2016 7:51 pm
- Forum: S6-I / S6Plus Technical
- Topic: Crank setup
- Replies: 4
- Views: 10205
Crank setup
Hi, I’m currently trying to configure a S6Plus to my engine. The engine is running with the normal ECU, injection and Ignition, I only try to get some sensors to work at the moment. I want to run it in 360° mode without cam Sensor. Therefore I have a custom 30-2 crankwheel and a Hall-Sensor. If I se...