Syvecs Forums

Started to play with this - any suggestions what frequency is the right starting point in the settings for a fuel injector?

Is it possible to use a fuel injector (high impedance) with the Syvecs wmi? Have wondered based on the manual images?

Aquamist FAV works with frequency of 10hz - thankyou.

10hz. New firmware makes this possible by the looks of things

I’m about to wire in the flow sensor. Any info on how to do this so it works?

+1. Dual injector control would be fantastic

Thanks. Actually solved the map by switching canbus. Also found out that map on syvecs only measures above 0kpa gauge (1000mbar absolute)

Not sure if I found a bug or some other issue - but when installed in a Porsche 991 with the 991 canbus receive, the map1 value is always zero. I’m getting both rpm and tps correctly. Attached a screenshot and confirmed on my data logger than map single is being measured there. Hopefully this is a b...

+1. This would be very useful.

I started setting up the WMI controller. My goal is that With Cal1 the injection is off, then Cal2 and Cal3 have individual settings (setting up on 991 which has 3 cal settings). I have the duty set as zero for Cal1 (not injecting). However I can’t figure out how to control the pump separately for e...