Syvecs Forums

I have connectected a syvecs 50hz gps to my s6gp via can and I have a aem cd7 dash off the same can. The dash works perfectly. The syvecs gps doesn’t. Issues I am having is The gps coordinates show my I am near the North Pole and gps speed shows I am doing 360mph while on my drive. Could anyone shed...

hi i am trying to set my dash up via can, and i was unsure at what baudrate syvecs uses, does anyone know this.
many thanks andy

Thanks Steve
Yes I do have wideband, the injectors are exactly same make and type of injector so I would pressume dead time would be same , hopefully
Thanks again

That's good to hear Steve, thanks mate
Could you explain in simple terms how to do this pls
Thanks Andy

Hi I have recently had a failed injector and so I had them cleaned and flow checked Tested at 4 bar 1-1284cc 2-1220cc 3-1282cc 4-1288cc So I tried to get a matched one from the company where I bought them from but couldn't get it as close as I would want so I swapped them all for a matched set but t...

I have re loaded base map on and charged batt and it runs
I am going to download software and update firmware for dash to latest 9.35
Then I will load new dat file I have from rt with adjusted map they sent me and give it a try
Fingers crossed

Thanks for replys Paul, yes I have a can bus I have contacted race technology's and they told me to send them my base map, then they will install the new datastream onto it for me, so I did this, then they sent it back So I tried to load it on my ecu tonight and it said errors So I looked into the e...

Hi
I am trying to set my race technology's dash 2 up with my syvecs s6 gp
I believe I need a config file to enable the dash 2 to receive date via rs232 from ecu.
Any help on this would be greatly appreciated
Thanks andy